Customized jewellery needle setting refers to the use of a small shovel crushed by a sewing needle to scoop up copper pieces, and further shovel the metal material hillocks that produce nuisance. After attracting beads, it becomes a small nail with a round top. The method of fixing the crystal stone by extrusion molding.
Jewelry customization
Lixin recommends the starting needle inlay process:
Jewelry processing Among many embedding methods, nail setting is a very difficult method. In addition to the actual operation method, because the individual shoveling nails is small, the operator is also required to have good eyesight. Ek olarak, this method is mainly used to embed the round and multi-cut spar. The size of the spar is small, and the embedded bare diamond generally does not exceed three points. If the stone is large, the firmness is very prone to problems. According to the total number and characteristics of nails, the nails are set with common nails (also called double nails), two nails, three nails, four nails, osmanthus nails and random nails, among which the two nails can be divided into There is a slight difference in the method of categorizing dead nails and diagonal nails.
Jewelry processing
Silver jewelry processing an ornament usually chooses a large number of nail inlays, or even the composition of two nails, three nails, vesaire., so that the order of each inlay can show various and common key wire types Sorting, symmetrical sorting, triangle sorting, surface sorting, standard sorting and irregular sorting, vesaire., all of which have laid a very good basis for processing technology to complete the diversity of the design scheme.
Silver jewelry processing
As far as nail setting is concerned, it is not only different from nail setting, but also inseparable. The nail setting is nailed by the pattern picker, and the embedding process is carried out by the embedder; the nail setting is The embedder takes the nails and embeds them. As far as the nailing method is concerned, the two are the same. Only in the embedding process of the nail plate setting, the nails have been taken in advance, and only according to the car setting, the stone setting, the nail fixing stone, the suction of the nail, vesaire. The process flow is carried out; and the nail setting is embedding according to the process flow of car setting, lowering the stone, removing the nail and fixing the stone, and sucking the nail with the suction bead.
It can be said that the nail plate setting is only a component part of the nail setting process flow. Due to the lack of the nail setting stage, the whole process of embedding is becoming easier and easier to operate. Although in some jewellery productions the rough edge setting is described as an independent embedding method, and the appearance of the rough edge setting is very different from other embedding methods, but in terms of the way of contacting the spar, It uses a steel spatula to pick up four nails in a symmetrical way to contact the inhibitor spar, so the burr setting belongs to a unique type of nail setting.