Jewelry customization The whole process of co-nailing (also known as double nails) การตั้งค่า. This kind of nailing method is to arrange the inlays in a row. Because of the small interval between the inlays, there are only common nails.
การปรับแต่งเครื่องประดับ
Lixin recommends co-nailing and inlaying processing technology:
1. Fixed metal bracket
For jewelry processing, use a welding machine to heat the lacquer seal, place the metal holder on a wooden stick with a lacquer seal on the top, and flatten it. The metal holder should be glued firmly and the edges should be sealed to prevent deformation. Overflow, use a sewing needle to hollow it out before embedding.
การแปรรูปเครื่องประดับ
2. Renovate the insert
Silver jewelry processing on behalf of the application of the appropriate size of the corrugated needle to trim the inlay, the top of the corrugated needle is usually stained with mud like leather to facilitate the stone. นอกจากนี้, it is necessary to straighten the mounting car, and do not make the rim skewed, otherwise the stone is very easy to skew. The deep layer of the mounting car should be considered after the stone is laid and the surface of the stone is flat with the surface metal. If it is higher than the metal surface, the mounting Stone is not easy to be strong.
การแปรรูปเครื่องประดับเงิน
3. Put the stone
can use the top-quality sewing needles stained with leather mud to stick the spar, (the spar cabinet countertop) put it in the inlay mouth, to adjust the inlay.
4. Press stone
Use a machine needle with a flat top to vertically bisect the spar on the cabinet countertop to clamp the spar. ตัวอย่างเช่น, the spar is skewed. Do not use special tools such as medical tweezers or machine needles to clamp the spar tightly against the inlay. It is not easy to set the stone. After removing and pressing the stone, the spar cabinet countertops are the same height, and the spar is arranged in order.
5. Shovel nail
(1) Advance preparation of steel shovel
Since the individuals who need to lift the nails are relatively small, they need to grind the sewing needle on the diamond, and then use the sharpening technique to grind the top of the sewing needle into a small shovel with an angle of 90° on the opposite side. Appropriate posture.
(2) nailing
For co-nailing, there are two types of nailing methods, namely, the common nailing method between the two inlays and the nailing method at the corners of the edge setting. The first method of lifting is to sort the direction along the inlays. On both sides of the two inlays, use a steel shovel to shovel at 30°, slowly shovel deep and raise it to 60°, lift up a piece of copper, and then extend it with a steel shovel The two sides of the copper sheet are shoveled into a metal spatula.
6. Shovel edge
Use a steel shovel to insert the shovel along the inlaid edge, and choose the method of pushing and picking to make the metal edge on the side of the stone row continue to shine.
7. Suck the nail round
Use a suction bead of a suitable specification to suck the top of the nail round. You can use a gold sewing needle to drill a concave on the top of the needle to make the suction bead. When self-made suction bead tops, it is best to use the suction bead Like leather mud, on the one hand, it reduces the hotness of the nail suction, and on the other hand it makes the nails look brighter after suction.